I have a an SBT engine in my 2006 AR210, which runs fine. Since install I have had a cam sensor fault, it doesn’t seem to affect performance, other than a rough idle vs starboard. I have swapped the sensor and ECM from port to starboard and the error code stays with the port engine. I was able to shot the harness and the sensor and found good continuity in the harness and the sensor passed testing. On a whim I checked the boards and found someone with a similar issue, and mentioned that the valve cover was slightly higher on the new motor. I don’t see a fix or recommendation on that post. Is it possible this is the case with mine and what would you recommend to fix the issue?